What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 27.06.2025 02:31
First Sentence:
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
USA roster: 15 MLS players called for 2025 Concacaf Gold Cup - MLSsoccer.com
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
(Dc diagram shown, AC is similar).
The other is “what does a “fuse” do?”
Kroger Faces Backlash as Juneteenth Cakes Go Viral - Newser
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There are two important concepts here.
At one ohm, the resistor has a maximum of 1 watt power.
what exactly is a ‘surge’ protector?
These are simplified answers to the original question, and does not change anything I wrote above.
This device then solves the entire problem.
How do organic ready-to-eat meals compare to conventional ones?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
It also is a device that limits the change in current flow.
What is the best sunscreen available for summers? My skin is oily.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–10[John johnson John Johnson ]
2024–10–14 [Omar Gharbi Omar Gharbi ]
This Week In Space podcast: Episode 163 — The Trials of Starship - Space
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
'It's such a dream': Top high school performers step out on Broadway - NPR
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Here is a simplified AC power diagram.
It seems Mohan does not understand the difference between a comment and an Answer.
One is “what exactly is in a ‘surge protector’ ? ”
[old diagram got deleted by accident]
An AC voltage/ current source, and an ac inductive load.
This is 'the assistant's answer'
2024–10–16 [ OO OLAOYE OYEBODE ]
Edit 2024–10.
But it can get overloaded, and no longer works.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Upvotes:
I post the exact comment here.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
so, what happens?
Because the load is inductive, the current lags the voltage.(by a bit).
What does a fuse do?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is where this question deviates from being a 'generic' question, and becomes more specific.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At least they know the answer if they wanted it.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Barnstars:
Now when you have a certain ac resistance, then a current flows in a loop.
This is where the MOV conducts again, and dissipated the energy.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One
There are three different concepts here that are getting confused.
but I think this circuit , shows a few more pieces.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
A circuit breaker is similar, but is resettable.
He then describes Rainy Season and Lightning.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
[image of Common-mode choke]
a photo is worth a thousand words.
nine
What is lightning?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
These devices are installed between the “hot” and “neutral” and protective ground.
The bolt then partially travels down the line to your home.
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then describes the function of a fuse.
In schematic diagrams this is the symbol for a fuse:
But… the neutral is now “floating” because of the 1 ohm resistance.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
A fuse is a non-resetable over current circuit protector.
This one hit behind the barn.
the problem then depends on "how fast does the fuse operate?".
So, the voltage could go up to 500 volts, and the fuse will not open up.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
eight
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
He then asserts :
but this device (an Inductor) … impedes the rapid changes in the current.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
For this case there are devices called Metal oxide varistors (MOV).
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The third is lightning and “how it gets conducted into a home.”